0118738R9 Page 7 of 17
Optional Flip-up Shelf installation
Laminate Side Panel
(interior view)
Upper shelf
position holes
Lower shelf
position holes
Figure 6A
Laminate
Metal
Proceed to Step 2
Installation video available
See www.spectrumfurniture.com
(8) 0100167
8-32 x 1/2” PH
Thread-cutting screw
(8) 051696
8-32 x 1” PHMS
(8) 021588
8-32 Keps Nut
(8) 0285
3/16 Flat Steel
Washer
Figure 6B
For laminate side panels
For metal side panels
(1) 039622
2” Grommet
(1) Flip-up shelf
assembly
Attaching to laminate side panels:
1. Open the lectern door and remove the rack cube
(if equipped).
2.
From inside the lectern, use a drill with a 3/16”
drill bit and slowly drill out the corresponding
pre-drilled pilot holes located on the laminate
side panel.
Figure 6B
. Masking tape can be
used on the exterior to minimize chip-out.
Drill with
3/16” drill bit
1. Determine:
• The side of the lectern the shelf will be installed. (Left or right). Note
the shelf will install on the opposite side as the drawer.
• The shelf position: (Upper or lower)
• Type of side panels your lectern has (metal or laminate)
Figure 6A
26”D
[66 cm]
19.25”W
[48.9 cm]
7.5”H
[19 cm]
Figure 6
