0118738R9 Page 6 of 17
Figure 5A
Figure 5
Quick-
release
lever
Optional Rack Cube
The removable rack cube (12RU) simplifies installation and provides the ability to integrate equipment
remotely. The cube can be installed into the lectern at a later date. The cube also provides mounting
capabilities for multiple cooling fans if necessary. Compatible with most 4.75” cooling fans with 4.13”
mounting hole spacing (12 mounting locations available).
Figure 5
.
1. To remove the rack cube, open or remove the doors.
Figure 5A
.
2.
Unscrew the #14 x 7/8” PHSM screw from the base, and slide out the cube.
Figure 5
.
• To move the rack cube to the other side of the lectern, all that is needed is to remove the (5)
bumper stops in the base panel with a 4mm hex wrench, and relocate them to the opposite side of
the base panel. The doors can easily be removed and switched using the quick-release levers.
Removable Rack Cube
(Can be installed on left
or right-side)
Primary Door
(Removable-can be installed
on left or right-side)
Secondary Door
(Removable-can be installed
on left or right-side)
(1) #14 x 7/8
PHSM to secure
cube to base
Keyboard Tray / Drawer
1.
To flip, pull the tray out fully and locate the black plastic lever
on each slide.
Figure 4
.
2. Release the levers on the both slides while pulling the tray out.
3.
Flip the tray over, re-align the slides, and push back in.
Note: Can be used as a keyboard tray, or flipped and used as a drawer.
Figure 4
Push here on both
slides to release
Keyboard Tray
