0119509R1 Page 2 of 3
5. Locate the (6) starter holes in the back of the audience-side panel.
Figure 1C
.
6. Using a 3/8” drill bit, slowly drill completely through the panel at the 6 hole locations.
7. Align the logo panel studs with the drilled holes and secure with (6) 1/4-20 locknuts.
Figure 1D
.
8. To re-install the audience-side panel, insert the panel tabs into the slots in the base panel, then
tip the panel back into position. Replace the knobs, and tighten securely.
Figure 1C
Figure 1D
Removed
Audience-side
panel
1/4-20 locknuts
(6 required)
Logo panel
Removed
Audience-side
panel
Carefully drill through
the panel with a 3/8”
drill bit (6 holes total)
Use a sharp 3/8” drill bit to drill out the (4) existing starter holes.
Drill slowly to minimize laminate chip-out around the holes.
Placing masking tape on the laminate-side of the panel at the
hole locations before drilling will also help minimize chip-out.
