Spectrum Illumination, Monster Brain Controller Manual
17
Rev. Date: 2013-11-27
Section 6 - Setting Product ID with I/O
1) To change Product ID code with an I/O card, run wires from the I/O card to the
blue connectors, in the following order:
Pin 1 = Product ID B0 (LSB)
Pin 2 = Product ID B1
Pin 3 = Product ID B2
Pin 4 = Select
Pin 5 = Product ID B3
Pin 6 = Product ID B4
Pin 7 = Product ID B5 (MSB)
Pin 8 = Acknowledge Output
2) When changing the Product ID determine which Product ID to run. Next, bring
the appropriate bits (as charted on next page) to appropriate logic levels. Hold
these bits then send a logic high to Pin #4.
3) The Monster Brain will receive your signal and send an acknowledge signal back
to your device from Pin #8 (logic low). The output will send a pulse train equal to
the Product ID # + 1, i.e. product ID 11 will result in 12 logic low pulses.
Note: Product ID # 63 is a special ID that when selected all Product ID’s are run in
sequence (0 to 63) when triggered. This is typically used to demonstrate the
product. Can also be used to create a custom sequence from a single trigger input.
