6
3
ACCESSORIES
LAMP WITH CARRYING HANDLE
SE-140 LAMP STAND
CM-26 UV VIEWING CABINET
NOTE: For even greater comfort and convenience, all E-Series
hand lamps are now equipped with a carrying handle. Or for
hands-free operation, the SE-140 lamp stand is available. Any
E-Series lamp may be slipped easily into and out of this stand. To
increase fluorescent contrast, all 4-, 5-, and 6-watt E-Series lamps
may be used with Spectroline CM-Series UV viewing cabinets.
OPERATOR SERVICING
The following servicing instructions are intended for limited main-
tenance of the lamp. Do not perform any servicing other than that
contained in these instructions. Return the lamp to the factory for
maintenance not covered in this section.
HOUSING AND FILTER MAINTENANCE
The aluminum lamp housing is designed for protection of the
internal parts. Using a soft cloth, immediately clean spills from the
housing with water and a mild detergent and wipe dry. Take care
not to allow any liquids to leak into electrical components.
Periodically clean the filter with a glass cleaner and a soft cloth.
TUBE AND REFLECTOR MAINTENANCE
To clean the tubes and/or reflectors, remove the tubes according
to the instructions outlined in the ‘‘TUBE REPLACEMENT’’ section
below. Using a soft cloth, the reflectors may be cleaned with a
glass cleaner, while the tubes may be cleaned with a mild
detergent solution. Wipe dry with a soft cloth.
TUBE REPLACEMENT
If a tube fails to operate correctly, review the procedures outlined
in the ‘‘OPERATION’’ section. If the problem persists and it is found
necessary to replace a tube, unplug the lamp from its power
source before proceeding.
WARNING
To avoid the risk of electrical shock, always unplug the lamp
from its power source before cleaning or servicing.
