5
4
CARRYING CASE
PART NO. XCC-100
DUAL UV-A/VIS
SENSOR DETECTOR
PART NO. XDS-1000A
USB CABLE WITH
WATER-RESISTANT
SENSOR ADAPTER
PART NO. XCB-100
PROTECTIVE RUBBER
BOOT FOR
READOUT UNIT
PART NO. XRB-100
METER READOUT UNIT
PART NO. XR-1000
2.3 ELECTRICAL SPECIFICATIONS
Two nonrechargeable 9-volt alkaline batteries are
included. Fresh batteries will provide a typical, usable
operation period of 12 hours.
2.4 OPTICAL ACCURACY AND CALIBRATION
The AccuMAX™ XRP-3000A radiometer/photometer kit
uses a dual-wavelength UV-A/VIS sensor detector to
simultaneously measure both ultraviolet and visible
light. Featuring automatic zeroing, integration and
signal hold, the unit provides accurate readouts for
UV irradiance and visible illuminance. The LCD readout
features ±0.2% linearity with the sensor sending the
linearity correction data to the readout unit during initial
power-up. To ensure consistent results, sensors are
designed with superior bandpass filters, while optical
stacks are assembled in Class 100 clean workstations.
For precise spectral coverage, these high-quality
interference filters will effectively resist degradation.
2.5 ENVIRONMENTAL SPECIFICATIONS
The AccuMAX radiometer/photometer is designed to
be safe under the following conditions:
Indoor use;
•
Altitude up to 2,000 m (6,562 ft.);
•
Temperature 5°C to 40°C (41°F to 104°F);
•
Maximum relative humidity 80% for temperatures
up to 31°C (88°F) decreasing linearly to 50% rela-
tive humidity at 40°C (104°F);
•
Mains supply voltage fluctuations not to exceed
±10% of the nominal voltage;
•
Installation Category II;
•
Pollution Control 2.
2.2 TECHNICAL DATA:
AccuMAX™ XRP-3000A SPECIFICATIONS
Readout Unit (XR-1000)
Resolution
4-digit autoranging display with backlight
Screen
128 x 64-dot pixel chip on glass STN transmissive monochrome LCD
2.8 in (7.1 cm) diagonal
Sampling Rate
7.5 Hz (Single Sensor)
15 Hz (Dual Sensor)
Read Update
2
Hz
Overall Accuracy
Better than ±5% with reference to NIST standards
Temperature Coefficient
±0.025%/°C (0 to 50°C)
Dual UV-A/Visible Sensor Detector (XDS-1000A)
Measurement Range
Spectral Range
• UV-A Sensor
0-100 mW/cm
2
320-420 nm
• Visible Sensor
0-5,300 lux (0-500 fc)
460-675 nm
Power Requirements
Battery Operation
Two nonrechargeable 9V alkaline battery cells are included as standard
Dimensions
Readout Unit
• Length
7.75 in (19.7 cm)
• Width
4.25 in (10.8 cm)
• Thickness
1.25 in (3.2 cm)
• Weight
0.8 lb (360 g)
Sensor
• Length
4.75 in (12.0 cm)
• Width
2.0 in (5.1 cm)
• Thickness
7/8 in (2.2 cm)
• Weight
0.22 lb (100 g)
Accessories
• USB cable with water-
resistant adapter
XCB-100
• Rubber boot
XRB-100
• Carrying case
XCC-100
•
Unpack and inspect the AccuMAX for possible damage in shipment. Check that all components are included.
Save the shipping carton and packing materials for future storing or shipping of the AccuMAX.
•
Check the performance as soon as possible. If damage is noted, immediately notify the carrier and supplier
and do not use the instrument.
Product Description
Part Number
METER READOUT UNIT
XR-1000
DUAL UV-A/VIS SENSOR DETECTOR
XDS-1000A
USB CABLE WITH WATER-RESISTANT SENSOR ADAPTER
XCB-100
RUBBER BOOT FOR READOUT UNIT
XRB-100
CARRYING CASE
XCC-100
Component Check List
2. GENERAL SPECIFICATIONS
2.1 UNPACKING AND INSPECTION OF XRP-3000A NDT METER KIT
