4
Installing C500
CAUTION:
TO AVOID ELECTRIC SHOCK, FIRE OR
FAILURE, Combo must be installed in a clean, dry location
where it will not come into contact with water or moisture.
DO NOT USE THIS APPARATUS NEAR WATER.
Place the C500 player on a level, stable surface. All four feet must be
securely seated on the moun
ti
ng surface.
Do not disconnect cables from audio components (including Combo) while
power is on.
Plug the C500 player’s power cord into the same power strip your sound
system is plugged into. Use only 120VAC 60 Hz power.
If needed, use only with brackets
specifi
ed by the manufacturer, or sold
with the apparatus.
Note:
For players connected to the network THE PLAYER MUST BE
POWERED OR IN STANDBY mode in order to receive scheduled content
updates.
Note:
ALWAYS POWER OFF YOUR AMPLIFIER BEFORE CONNECTING THE
C500 PLAYER. Also be sure to verify that Combo is turned OFF and that
your ampli
fie
r equipment is turned down to its minimum volume se
tti
ng
before connec
ti
ng.
Analog Audio - Connect an audio cable to the “Zone 1” RCA audio output
on the back of the C500 player. Connect the opposite end of the cable to
your ampli
fie
r equipment. Repeat these steps for “Zone 2” if a second zone
is required. Refer to the plug-and-play diagram provided by Spectrio if
available.
If content is to be delivered via network, connect a CAT5 network cable to
the connector into the back of player and connect the other end to your
network access point (router, hub or wall port).
Power up the C500 player by pushing the Power bu
tt
on on the front panel.
The C500 player will ini
tial
ize and play music and other programmed
content from its hard drive within 2 minutes. Adjust the volume of your
ampli
fier
equipment to the desired listening level.
Do not stack non-Spectrio objects on top of player as this may impede
proper heat v
entil
a
ti
on of the C500 player. Leave at least six inches of
clearance on both sides of the unit for adequate v
entilati
on.
Keep the C500 player free of dust, grease and dirt.
