5b. When set up vertically, press and release
button 4 to open the PlaneLok submenu; select
the
desired PlaneLok axis
then press
button 4 to start PlaneLok.
(
Y only with GL622N
)
Note:
When used in
vertical mode,
the
receiver
has to be placed with the
photocell on the bottom side.
The HL
760
display shows a flashing
–PL–
during the time the laser is searching and adjusting the beam to the
on-grade position.
When PlaneLok is complete,
–PL– stops flashing
at the HL
760
display.
Note:
The laser continues to servo to the receiver’s signals.
6.
Exiting of PlaneLok
can be done by pressing
button 3 (ESC).
Note:
If the setup will be disturbed for a minute (beam will be blocked),
an Alert comes up. After deleting the error message with
button 4
PlaneLok needs to be started again.
It’s recommended to use the
batter board adapter
M402
for setting up the GL6X2N and the
105516
vertical
adapter
for setting up the HL
760
.
Automatic PlaneLok mode
Содержание GL6X2N
Страница 1: ...May 2017 GL6X2N Hands On training...
