Specter Off-Road, Inc. 21600 Nordhoff St.
Chatsworth, CA 91311 USA, www.sor.com,
[email protected], (818) 882-1238, Fax: (818) 882-7144
5. Locate the loops sewn inside of the seat cover. There
are two sets of loops. One on the inside side front of
the seat cover and one on the inside back. As you did
with the seat cushion, insert a retainer wire through
the loops (see figure 2-5). The wire should extend all
the way through the loops. The loops and wire should
align with the slot in the seat back foam.
6. Starting with the back set of loops and working
through the slot in the seat pad (figure 2-6), use hog
rings to attach the loops and retainer wire (figure
2-6B) to the seat frame. Repeat the process to
attach the front seat cover loops and retainer wire
to the frame.
7. Check to confirm the seat cover is aligned to the
foam. Continue unfolding the seat cover until it
completely covers the entire seat back (figure 2-7).
Turn the back rest upside down. Pull the cover tight
over the foam.
8. Figure 2-8 — Thread retainer wires through the front
and back seams at the bottom of the seat cover. Use
hog rings to attach the front and back seams together
(figure 2-8B).
Figure 2-5
Page 7
© Copyright 2016 Specter Off-Road, Inc.
All rights reserved
Figure 2-7
Figure 2-8
Figure 2-8B
Figure 2-6B
Figure 2-6
