Specter Off-Road, Inc. 21600 Nordhoff St.
Chatsworth, CA 91311 USA, www.sor.com,
[email protected], (818) 882-1238, Fax: (818) 882-7144
7. Figure 1-7 — Starting at the front of the cushion,
roll the cover over the cushion turning it right side
out over the cushion. Make sure to keep the seams
aligned with the edges of the cushion. Continue
working the seat cover over the cushion working from
front to back checking alignment (figure 1-7B). Double
check fit and alignment (figure 1-7C).
8. Figure 1-8 — Place the seat top side down on a soft
surface as to prevent damage to the new cover. Use
an old blanket or large towel. From the bottom side of
the seat, pull the cover tight by pushing down on the
frame while pulling up on the edges of the cover. Turn
the seat over and recheck alignment.
9. Figure 1-9 — Working from the bottom of the seat
again, thread the appropriate length retainer wire
through seams in the all bottom edges of the seat
cover. Cinch it tight by pulling firmly but gently on the
ends of the wire being careful not to tear the vinyl.
10. Starting at the center on the front edge of the seat,
begin attaching the cover to the frame. Clamp hog
rings around the retainer wire through the vinyl and
through the loops in the seat frame (see figure 1-10).
Work from the front of the seat to the back working
both sides simultaneously.
Page 5
© Copyright 2016 Specter Off-Road, Inc.
All rights reserved
Figure 1-7C
Figure 1-7B
Figure 1-8
Figure 1-7
Figure 1-9
Figure 1-10
