INSTALLATION INSTRUCTIONS
STEP 1
The spa cover must be in the closed position prior to
mounting the lifter. Position the spa cover properly so it is
sitting squarely on the spa. Attach the
mounting bracket
near the back, and
close to the top edge of the spa, using the #10 - 1”
woodscrews. e recommend pre-drilling the all holes with a
1/16” drill bit.
STEP 2
nsert the longer
corner support
arms
the center pole
is situated parallel to the
spa cover
hooks
the
rat
STEP 3
STEP 4
ILLUSTRATION 3
ASSEMBLY OF CORNER ARMS TO PIVOT ARMS - FRONT VIEW
SUPPORT
ARM
CORNER
ARM
CORNER
SUPPORT
CENTER POLE
PIVOT ARM
PIVOT ARM
AM GRIP AND COVER HOOK ASS MBLY
Use warm water
to
lubricate the foam grip and slide it over
the corner support arm. Slide the cover
hook onto the longer end of the corner
support arm
(Illustration2)
FOAM GRIP
CORNER
SUPPORT
ARM
FOAM
GRIP
ILLUSTRATION 4
ASSEMBLY OF SLIDER ARM TO PIVOT ARM
SIDE VIEW
SLIDER PIVOT BRACKET
MOUNTING BRACKET
(ROTATE DEPENDING
ON CHOSEN MOUNT)
B
PIVOT ARM
CLEVIS PIN
BOLT PIN
COVER
HOOK
COVER
HOOK
COVER
HOOK
PRE-ASSEMBLY
Insert the two round plastic caps into
the open end of the round side pivot
arms. Insert the square plastic caps
into the open ends of the slider pivot
bracket.
*Note: Round plastic caps may not
be necessary if metal cap already
exists on round pivot arm
Assemble the 2-piece mounting
bracket using 2 of the 5/16 - NC ny-
lock nuts.
SLIDER PIVOT BRACKET
x 2
ROUND PIVOT ARM x 2
Be sure the three holes are facing away from the tub and
the ball stud bracket is facing down.Slide the pivot arm over
the shorter end of the corner support arm. Align the pivot arm
with the holes identified as “B” on the slider pivot bracket and
feed the bolt pin through the bracket, through the nylon washer,
through the round pivot arm, and secure using the clevis pin
(illustration 4)
Ball Stud
Bracket
