8. Heart Rate Zone Calibration
The heart rate zone can be adjusted to suit
your personal training program (For more
information on heart rate training please
consult your doctor). To enter heart rate zone
calibration mode push the right button until
the Top Line Function Cursor is under the
Time In Zone icon. Simultaneously hold the
top and right buttons down for three sec-
onds. The heart rate zone lower limit will
begin flashing. Use the right button to scroll
up and the left one to scroll down. Each
push of the side button will change the heart
rate 5BPM (beats per minute). Hold the right
or left button to scroll through the digits rap-
idly. When the desired selection is displayed,
press a side button and the top button simul-
taneously. The heart rate zone upper limit
will begin flashing. Again, use the right but-
ton to scroll up and the left one to scroll
down. When the desired selection is dis-
played, press a side button and the top but-
ton to exit heart rate zone calibration mode.
Note:
If the heart rate lower limit is blink-
ing when you are not in calibration mode, it
is an indication that your heart rate is below
your lower limit setting.
COMPUTER FUNCTIONS
Clear stored data
To erase all of the stored data in the
P•Brain, press and hold the top button for
three seconds. This will reset the Average
Speed, Maximum Speed, Average Heart
Rate, Time in Zone, Altitude Sum, Timer and
Trip Meter to zero. After this data is cleared
your SpeedZone P•Brain is ready to begin
a new tour.
Note:
Clearing stored data will
not erase previous tours that are stored in
your P-Brain.
Speedometer
The current speed is indicated on the top line
of the screen when the Top Line Function
Cursor appears under the current speed
icon. The speed is shown continuously up to
67.0M/h (99.9 Km/h) with a resolution of
0.1 M/h (0.1 Km/h)
9
6. Setting the Programmable Odometer
The odometer digits are user settable. This is
convenient for transferring your hard-earned
mileage that is usually lost when changing
batteries or computers. The odometer read-
ing will be flashing when you are in odome-
ter programming mode. Use the right button
to scroll up and the left one to scroll down.
Each push of the side button will change the
odometer one mile (or kilometer if you
selected metric units). Hold the right or left
button to scroll through the digits rapidly.
When the desired selection is displayed,
press a side button and the top button simul-
taneously. You will now exit Program Mode.
7. Altimeter Calibration
Your SpeedZone P•Brain contains an
extremely accurate altimeter that is capable
of recording changes in altitude in incre-
ments as small as three feet (one meter). This
altimeter calculates altitude by precisely
measuring barometric pressure. Due to nor-
mal fluctuations in barometric pressure, you
may need to recalibrate your SpeedZone
P•Brain on a daily basis. You should be able
to find the altitude where you live on a topo-
graphical map or by contacting a nearby
airport. To enter altimeter calibration mode
push the left button until the Bottom Line
Function Cursor is above the Altitude
icon. Simultaneously hold the top and left
buttons down for three seconds. The altitude
will begin flashing. Use the right button to
scroll up and the left one to scroll down.
Each push of the side button will change the
altitude one foot (or meter if you selected
metric units). Hold the right or left button to
scroll through the digits rapidly. When the
desired selection is displayed press a side
button and the top button simultaneously.
The word ON or OFF will begin blinking.
You can now choose to enable or disable the
altimeter recording function. Either the left or
the right side button will toggle the display
between ON and OFF. When the desired
selection is displayed press a side button
and the top button simultaneously. You will
now exit Altimeter Calibration Mode.
8
