Specialized Enduro Comp, Руководство пользователя

Страница: 14 / 28

11
5.2. PIVOT ASSEMBLY
To properly assemble the Enduro, grease the surfaces of unthreaded bolt shafts, and spacers
that interface with bearings (highlighted ORANGE). Follow the specific order as listed below:
1. LOWER LINK @ CHAINSTAY
N : LOWER LINK SLEEVE
15 x 23.5 x 27.1 W
O : DS LOWER LINK SPACER
17.1 ID x 23 OD x 4.5 W
Q : NDS LOWER LINK SPACER
15.1 ID x 23.5 OD x 3 W
P : LOWER LINK SLEEVE
15 x 23.5 x 27.1 W
NON-DRIVE
SIDE
DRIVE
SIDE
NON-DRIVE
SIDE
DRIVE
SIDE
„
Grease, then insert the non-drive side sleeve N into the link. Please note the link is non-
drive side / drive side directional.
„
Grease, then place spacer O against the drive side bearing, align the link and spacer
against the drive side of the seatstay, then grease and slide the drive side sleeve P through
the drive side main pivot bearing and into the link.
„
Grease, then place spacer Q against the non-drive side main pivot bearing.
DRIVE SIDE GOES
ON THE INSIDE
NON-DRIVE SIDE GOES
ON THE OUTSIDE
„
Align the main pivot of the chainstay and link assembly with the frame’s main pivot bore.
The drive side portion of the chainstay goes against the inside of the frame, while
the non-drive side portion of the chainstay goes on the outside of the frame.