Specac Atlas GS15800, Руководство пользователя, Страница: 22 / 48

User Manual
20
The front safety guard can be left open in its raised position (it will be
kept open because of the magnetic stop catch fitting) to allow for
access to the Film Maker Accessory for installation of a foil disc and
sample “sandwich” to be heated and pressed.
At this stage a water supply can be switched on for the cooling circuit
of the Film Maker Accessory. An adequate water flow rate for sufficient
cooling is circa 1 liter/minute.
Installation into Atlas™ Power and Autotouch Presses
For installation of the High Temperature Film Maker Accessory into an
Atlas™ Power 8T or Autotouch 8T Press, it is a similar procedure to
that described for the Atlas™ Manual Hydraulic Press, but the
entire
Accessory with the water cooling tubing fitted and electrical cable
connections are passed through the front of the Press (front safety
guard is raised) and the tubing and electrical cable connections are
carefully routed through the recess gap at the rear and to the base of
the
permanently fixed rear safety guard on these presses.
Note: For Atlas™ Power and Autotouch Presses the front safety
guard is a crucial safety feature for operation. The front safety
guard must be used in a down/closed position to allow power to
be supplied for automatic operation of the piston mechanism.
When the front safety guard is raised, power is cut for any
pressing operations.