Spearhead TWIGA FLEX 567, Руководство пользователя

Страница: 49 / 54

TWIGA FLEX
48
Regular Services Chart
Pump & Motor Failure Prevention
•
Never run out of oil.
•
Never run a cold machine straight up to speed, first ensure engine
revolutions are low then engage/disengage the head motor.
•
Never increase or decrease engine speed quickly.
•
Never stop or start rotor at high engine speed.
•
Never transport with P.T.O. in gear.
•
Regularly check condition of suction line hose.
•
Never operate above recommended P.T.O. speed.
•
Check that pump fittings are tight.
•
If any strange noise occurs from the hydraulics, stop immediately and
investigate.
•
Remember, pump and motor warranty is limited to replacement due to
faulty materials or manufacturer. Cavitations and peak pressures are
very easily detected on pump inspection.
•
Warranty will not be considered if fault is due to misuse.
•
Never cause severe sudden movements to arms. Pressure will peak
and will transmit back to pump, resulting in failure.
Service
Hours Service points
G
re
a
se
D
ra
in
C
h
e
ck
Clean Change
1-4 hrs Bolts are fully tightened X
Condition of flails X
Condition of hoses especially for chafing X
Flail bolts are fully tightened X
Flail head retaining bolts are fully tightened X
Gearbox seals (If oil is leaking replace immediately) X ( X )
Inspect leaks from fittings and pipes X
Pins and bushes X
Rotor bearing bolts are fully tightened X
8 hrs Bearings X
Gearbox & pump bolts are fully tightened X
Gearbox oil level X
Grease points & PTO shaft X
Motor Drive X
Maintain correct belt tension on head (only with belt
drive heads) X
Oil level in reservoir X X
U.J. joints
50 hrs Gearbox oil (use EP 90 oil) X X
250-300 hrs Return line filter element X
Hydraulic oil if any signs of contamination appears X X