Spearhead MULTICUT 820, Руководство пользователя

Страница: 10 / 27

Spearhead MULTICUT
820
10
Setting Up Your Machine
Levelling – Front To Rear
Once coupled to the tractor, check the mower is cutting level from the front to the
rear of the machine. This is important to ensure each rotor will cut at the same height
(Fig. 3). The machine has adjustable tie bars that can be lengthened to lower the
front or shortened to raise the front of the machine by turning barrel nut (Fig. 2).
Once satisfied the mower is cutting level, tighten locking nuts.
Levelling – Wings LH & RH
With the machine in the working position and the wings folded down it may be
necessary to alter the height of the wing to ensure each rotor is cutting level.
Between each axle there is an adjustable link shortening this will raise the cutting
height of the wing rotor and blades. We recommend the wing is set 12-25mm higher
then the centre
.
Warning
The machine is set at the factory with the centre deck 1” (25mm) higher at
the front and the wings ½” (12mm) higher to the centre section, when
mounted on the tractor drawbar at 16” (400mm).
When operating over uneven ground it is recommended to raise the front
of the machine by adjusting the tie bars to prevent scalping or damage to
the blades.