8999153EN: v1.0 18/12/2020
35
Original instructions (ENGLISH)
Website: www.spearheadmachinery.com
Use moisturisers after cleaning; preparations containing lanolin help replace the skin's natural oils
which have been removed.
If skin disorders develop, obtain medical advice without delay.
Wear eye protection (e.g. goggles or a face shield, if there is a risk of eye contamination. Eye wash
facilities should be provided in close vicinity of the work area.
WARNING!
Waste oil qualifies as hazardous waste according to current law and, as such, must not be
released into the environment; it should be recovered and disposed of through suitable collection
centres.
Consequently, contact your nearest environment agency concerned with the collection and disposal of waste oil
before commencing any maintenance work
6.3
Maintenance Work That Can Be Performed By The Operator
The work described in the following points does not require any special expertise.
The operator must be familiar with the procedures and follow the relevant instructions carefully, and
must put the machine out of service first.
Routine checks and maintenance work must be performed at the stated intervals following the
procedures given and are the responsibility of the operator.
Failure to comply with maintenance rules and intervals has a negative effect on machine operation and
its service life and, consequently, shall void the warranty.
Perform maintenance at shorter intervals when working under demanding operating conditions
(frequent stopping and starting, lengthy winter season, e.t.c).
6.4
P.T.O Shaft
Refer
to the manufacturer’s instructions, (supplied with the shaft) to adjust or service the P.T.O. shaft.
6.5
Gearbox
– Agricut 180
6.5.1
Check And Tighten Fixing Bolts
Figure 6.1
Check and tighten the gearbox mounting nuts and bolts; see Figure 6.1. Refer
to ‘Specific Torque
Settings’; see Section 6.14.
