Spear & Jackson SPJPM40B, Руководство по эксплуатации

Страница: 16 / 24

Helpline No. UK/Northern Ireland
0151 6491500
Rep. Ireland
1890 946244
16
10. Never place petrol near an ignition source.
Always use a can that is approved to store petrol.
Keep petrol away from children.
11. Oil and maintain the machine.
12. How to switch off the engine:
All you have to do to switch off the engine is
release the engine start/stop lever (Fig.
5a/Item 1).
Pull the ignition cable from the spark plug boot in
order to prevent the engine from restarting.
Before you start the engine again, check the cord
for the engine brake. Check that the cord is
correctly fitted. If the cord is kinked or damaged,
it should be replaced.
8. Cleaning, maintenance, storage,
transport and ordering of spare
parts
Important: The enclosed engine manual from
Briggs & Stratton provides maintenance
information and maintenance interval
information on the engine.
Important: Never work on or touch conducting
parts on the ignition unit with the engine running.
Always pull the spark plug boot from the spark
plug before starting any cleaning or maintenance.
Never perform any work on the machine while it
is running. Any work not described in these
Operating Instructions must be performed by an
authorized service workshop only.
8.1 Cleaning
After each use, the mower should be thoroughly
cleaned (especially the underside and blade
receptacle).
Note: Before you tilt the lawnmower onto its side,
empty the fuel tank completely with a petrol
pump. The lawnmower must not be tilted more
than 90 degrees. The simplest time to remove dirt
and grass is directly after mowing. Dried residual
grass and dirt could cause damage to the
mowing operation. Make sure the grass ejector
canal is free from residual pieces of grass and
remove these if necessary. Never clean the
mower with a direct jet of water or a high pressure
cleaner. The motor must stay dry. Aggressive
cleaning agents such as cold cleaning solvent or
petroleum ether must not be used.
8.2 Maintenance
Dispose of soiled maintenance material and operating
materials at the appropriate waste collection point.
8.2.1 Wheel axles and wheel hubs
A thin coating of grease should be applied to the
axles and wheel hubs once per season. To do so,
remove the wheel caps with a screwdriver and remove
the circlip and washer to allow the wheel removal.
8.2.2 Blade
For safety reasons you should only ever have your
blade sharpened, balanced and mounted by a
service workshop. For optimum results it is
recommended that the blade should be
inspected once a year.
Changing the blades (Fig. 7)
Only ever use original spare parts when having
the blade replaced. The marking on the blade
must be matched with the number given in the
list of spare parts. Never have any other model of
blade fitted.
Damaged blades
Should the blade, in spite of all precautions,
come into contact with an obstruction, shut down
the engine immediately and pull the spark plug
boot. Tip the lawn mower onto its side and check
the blade for damage. Damaged or bent
blades must be replaced. Never attempt to
bend a bent blade back to straight again. Never
mow the lawn with a bent or heavily worn blade
as this will cause vibrations and can lead to further
damage to the lawn mower.
Important: There is a risk of injury if you work with a
damaged blade.
Resharpening the blade
The blades can be resharpened with a metal file.
In order to avoid imbalance, the blade should be
resharpened by a service workshop.
8.2.3 Care and adjustment of the brake cable
Oil the brake cable inner wire at regular intervals
and check that it moves easily within the outer sheath.