Spear & Jackson S3630CT, Оригинальное руководство пользователя

Страница: 24 / 39

24
AFTER SALES SUPPORT
0345 605 2067
ASSEMBLE
This product comes with a lithium ion battery pack. Lithium Ion batteries don’t lose charge
when not in use, and don’t lose charging capacity overtime. Never the less it is best practice
to charge the battery when empty or insufficient to do the job.
Connect the charger into mains
1. Plug the charger into an appropriate power supply. The LED lights green to tell you that
the charger is ready for use.
2. To insert the battery pack into the charger, align the battery pack with the corresponding
receptacle on the charger, push the battery pack downward until it has been locked in
place
3. The battery pack will be fully charged in 1.5 hour. And the LED lights up green again to tell
you that the battery pack is fully charged.
Important charging notes
Longest life and best performance can be obtained if the battery pack is charged when the air
temperature is between 18-24°C. Do not charge the battery pack in a very low or very high air
temperature. This is important and will prevent serious damage to the battery pack.
■
When using your tool continuously, the batteries in your battery pack will become hot. You
should let a hot battery pack cool down for approximately 30 minutes before attempting
to recharge.
■
The charger and battery pack may become warm to touch while charging. This is a
normal condition, and does not indicate a problem.
■
Use the charger in normal room temperatures whenever possible. To prevent overheating,
do not cover the charger and do not charge battery packs in direct sunlight or near heat
sources.
■
If the battery pack does not charge properly;
(1).Check the main socket by plugging in a lamp or other appliance.
(2). Move the charger and battery pack to a location where the surrounding air
temperature is approximately 18-24
°
C.
(3). If charging problems persist, take or send the tool, battery pack and charger to your
local service center.