18
19
AFTER SALES SUPPORT
0345 605 2067
AFTER SALES SUPPORT
0345 605 2067
OPERATION
Using the detergent bottle
Special pressure washer detergents can be used to
increase the cleaning power of the pressure washer.
Detergent can only be used with low pressure
attachments like the adjustable lance in low pressure
setting, the rotary brush and the fixed brush.
i.
Make sure the machine is turned off and engage
the safety lock on the spray gun, before filling the
detergent bottle.
ii.
Unscrew the lid from the bottle and fill with detergent
diluted according to the fluid instructions.
iii.
Screw the lid.
iv.
Pull the adjustable lance nozzle forward, configuring
the machine to low pressure.
Note:
- The lance has to be set to low pressure for the
machine to engage when using detergent.
- Allow detergent to remain on the surface for a
short time before rinsing. Do not allow detergent
to dry on surface
-
Before you change the type of detergent for another
job, rinse the detergent tank with clean water.
Pull the trigger on the lance at low pressure for
one minute until all all detergent is flushed
through the system.
Use with water butt or reservoir
The machine can also operate with water from sources other
than a water tap, e. g. ponds and water butts. The use of an
additional water filter (not supplied) is highly recommended
for this kind of use.
Make sure the water source is situated no more than 1m
below the level of the machine. The water inlet hose must
not be too long, approx. 3 m. Fill water supply hose (not
supplied) with water before connecting it to the machine.
Running the machine without water (running dry) will
damage it. Run machine without lance attached until there is
a constant flow of water.
√
X
MAINTENANCE
Turn off machine and connect lance.
Note: The internal mesh filter of the machine is
not intended for the filtration of large quantities of
impurities.
Overview of cleaning
▪
After every use wipe the machine with a slightly damp
cloth. Do not clean the machine using a high-pressure
water jet.
▪
Clean the high-pressure jet nozzle.
The pressure washer is equipped with a water filter inlet
adapter to protect the pump. If the filter is not kept clean,
the water flow to the machine will be restricted and the
pump may be damaged.
To clean water filter, remove inlet adapter and get the
filter out.
▪
Rinse filter until it is free of debris and blockage.
▪
Replace the filter and inlet adapter.
Note: Keep the nozzle pin out of children’s reach.
Cleaning limescale
Over time limescale may build up on your lance outlet, use
the nozzle cleaning pin to remove this.
Storing
Store the machine where it is dry and well ventilated.
When placing the machine out of service for an extended
period of time, remove the cleaning agent and drain all the water
left in the hoses.
Always empty water from all hoses before storing.
Hold the hose, then turn the hose reel handle, make sure the
hose is rolled in a straight line and without kinking the hose.
CIick the cable clip on hose.
