Image 2:
When fixing the mounting plate to the TV set, make absolutely certain that you
use the correct screws. Not only must these be of the correct thread type for
the TV set, but they must also not be too long; otherwise they will damage the
TV set.
The screws must not be too short, however, since otherwise the connection
will not be secure. The screws must be screwed into the threaded fixture holes
on the TV set with at least 5 full 360° turns.
Should the screw length of the screws in the mounting set provided (M) are not
suitable for your TV set, please acquire suitable screws at your local hardware
store.
If you have any doubt about the correct length of the screws required, we rec-
ommend that you contact the TV manufacturer or an appropriate specialist.
• Fasten the mounting brackets on the rear of your TV set (image 2-1) using suitable screws and
washers from the mounting screw set (M).
• Should the back of your TV set be curved or if you want to mount the TV set with a bigger
distance to the wall, you can insert the spacers provided (M-G or M-H) between the mounting
brackets and the TV’s rear (image 2-2).
• During installation of the brackets make sure the openings of the bracket hooks point towards
the TV’s underside and the knurled screws for the inclination adjustment outwards.
• Do not use any force when tightening the screws; otherwise the TV set may be destroyed,
leading to loss of warranty/guarantee!
Image 3:
• Turn the safety screws on the undersides of the brackets fully back in order for the brackets to
fit into the profile of the mounting plate without any problem.
• Lift the TV set with the mounted brackets and place it onto the mounting plate from the top. In
this process, the TV set must be tilted with its upper side slightly towards the wall.
• The openings of the mounting brackets must be inserted neatly into the profile of the mounting
plate.
• Adjust the TV set in the centre of the mounting plate and tilt it until it sits closely at the lower
part of the mounting plate.
• Screw in the safety screws on the bottom sides of the mounting brackets in order to secure the
TV set on the mounting plate.
Image 4:
• Unfasten the knurled screws slightly to adjust the inclination.
• Adjust the desired inclination of the TV set and tighten the knurled screws of the inclination
adjustment again.
Maintenance and care
The product does not have to be serviced and, except for occasional cleaning with a soft, dry
cloth, requires no maintenance whatsoever.
Never use aggressive cleaning agents or chemical solutions as these may damage the surfaces.
Technical data
TV size .................................. 81-152 cm (32-60”)
Load capacity ....................... max. 75 kg
VESA fixture ......................... 100x100
..............................................
200x100
..............................................
200x200
..............................................
300x100
..............................................
300x200
..............................................
300x300
..............................................
400x100
..............................................
400x200
..............................................
400x300
..............................................
400x400
..............................................
600x200
..............................................
600x300
..............................................
600x400
Wall distance ........................ 68 mm
Inclination angle .................... ±10°
Material ................................. steel
Weight .................................. 2.8 kg
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represent the
technical status at the time of printing.
© Copyright 2014 by Conrad Electronic SE.
