SPE MS230-1, Руководство по эксплуатации, Страница: 5 / 15

2
MS230-1
MULTISRIPPER
Operating Manual
AFTER USE:
MAINTENANCE
- Clean the machine to remove all the build up of dust and surface residue. If using a
hosepipe or pressure washer take care that water is not directed onto electrical components
and switches.
(Note: Motors and switches are not waterproof)
- All components should be checked daily for tightness
BLADE CHANGE
1) Isolate from the power supply
2) Loosen the blade clamp bolts and slide out the blade. Insert the new blade and tighten the
clamp bolts
Note: The operator should be aware that the blades are sharp and use suitable
protection when handling them.
BLADE ANGLE
The angle of the blade can be altered to suit different applications
1) Loosen the thumb screws on either side of the chassis
2) Adjust the angle to a suitable setting
3) Tighten the thumb screws.
BASIC MAINTENANCE/CHECKLIST :
This checklist should be undertaken every 8hrs to 10hrs - taking into account the vibrating
action of machine
- DISCONNECT FROM THE POWER SUPPLY
- Check the condition of the blade
- Check all bolts and nuts for tightness
- Grease all moving parts on the sliding blade mechanism
- Check all the electric cables and plugs