SPE BEF320-1A, Руководство по эксплуатации, Страница: 8 / 32

BEF320-1A
Operating Manual
Height Adjustment Maintenance:
Ensure the height screw thread is cleaned and then lightly oiled. Periodically it should be
removed and the female threaded section cleaned out and oiled. At the same time the self-
aligning bearing should be greased.
The clevis pin should be oiled regularly to maintain a light, smooth height adjustment.
BEF320 Cutter Drum Adjustment:
Should the machine be cutting more heavily on one side. Stop machine and isolate power
supply, adjust lock nut/bolt assembly on top of right hand side of chassis. By adjusting up or
down the cutting action can be reset level again. Retighten all bolts. Test on sample area and
if required reset until cutting correctly.
Great care should be taken to ensure belts have correct tension and also correct alignment.
Serious damage could be caused to the drive shaft, drive shaft bearings and drive motor if the
belts are excessively tight.
Note: Never operate the BEF320 without belt guard fitted
5
Level Adjustment
bolt and lock nut
Slacken before
adjusting.
Tighten before
use.