2
IOM 81, Issue 2 - Modulo Thermostat
Contents
Page
1
|
Safety Instructions
3
1.1
|
EG-Conformity
3
1.2
|
General Instructions
3
1.3
|
Changes to the Unit
4
1.4
|
Warranty and Liability
4
1.5
|
Disposal and Pollutants
4
2
|
Description SPC Modulo Thermostat
5
2.1
|
Specifi cations
5
2.2
|
Scope of Supply
6
3
|
Installation
7
3.1
|
SPC Modulo Installation
7
3.2
|
Sample Wiring
9
4
|
Setup
9
4.1
|
Setup Procedure
9
5
|
Operation
10
5.1
|
Overview of Temperatures & Humidity
10
5.2
|
Operating Mode
10
5.3
|
Menu
11
5.4
|
Set Operation Hours
11
5.5
|
Expert Menu
13
5.6
|
Expert Menu Settings
13
5.7
|
Settings Functions
14
6
|
Fault Finding
15
6.1
|
Factory Reset
15
6.2
|
Hard Reset
15
7
|
Appendix 1
16
7.1
|
Setting Up Menu Lock
16
7.2
|
Setting Up Interface Lock
17
3
IOM 81, Issue 2 - Modulo Thermostat
1. Safety instructions
1.1 EC-Conformity
By affi xing the CE mark to the unit the manufacturer declares that SPC Modulo Thermostat conforms to
the following relevant safety regulations:
• EU low voltage directive 2014/35/EU
• EU electromagnetic compatibility directive
2014/30/EU
Conformity has been verifi ed and the corresponding documentation and the EU declaration of
conformity are kept on fi le by the manufacturer.
1.2 General Instructions
Please read carefully!
These installation and operating instructions
contain basic instructions and important
information regarding safety, installation,
commissioning, maintenance and the optimal
use of the unit. Therefore these instructions
must be read and understood completely by the
installation technician/specialist and by the system
user before installation, commissioning and
operation of the unit.
This unit is an automatic, electronic room
thermostat. Install the device only in dry rooms
and under environmental conditions as described
under “Technical Data”.
In addition, observe the applicable accident
prevention regulations, the regulations of the
Institute of Electrical Engineering, the local power
supply utility, the applicable BS-EN standards and
the installation and operating instructions for
the additional system components. Installation,
electrical connection, commissioning and
maintenance of the unit may only be carried
out by specialists who possess the appropriate
training.
Users: Make sure that the specialist gives
you detailed information on the function
and operation of the unit. Always keep these
instructions in the vicinity of the unit.
The manufacturer does not take over any liability
for damage caused through improper usage or
non-compliance of this manual!
