www.spatz-tech.com
16
(4)
If it is in
Standby
mode with the loop-through connection on, and the 1
st
display attached to
the trans A/V source is on (Transmitter POWER LED is lit in purple and Receiver POWER
LED is lit in red), press the POWER button of receiver to wake up and connect the transmitter
and the receiver.
Note:
If the user points the RCU at the transmitter instead, and press POWER button during this
period, however, the transmitter will enter Standby mode (LED lit in red) and turn off Loop-through
output.
(5)
During the warm-up, the POWER LED will blink in blue until the signal link between the
transmitter and the receiver is established.
Ensure your2
nd
TV set or projector is on “HDMI input” mode, and is already powered on.
