USER’S MANUAL
EN
20
10. TROUBLESHOOTING
Not all problems with functioning of the device, are the evidence of failure. You can independently carry
out an analysis in search of probable failure. In case of doubt, please contact to SPARTUS® dealer or
authorized service center.
During the warranty period all repairs should be carried by authorized service center. Repairs carried
out by unauthorized persons will void the warranty.
PROBLEM WITH TURNING ON THE MACHINE
The device does not correspond after
turning on the switch in ON position
Poorly connected to the supply voltage
Failure of power switch
MIG WELDING PROBLEMS
No arc
No power supply
A break in circuit welding
A break in the control circuit
Excessive heating of MIG gun
Contact tip is not properly fastened or tightened
Too high welding current in relation
into MIG gun capacity
Unstable arc welding
Contact tip is worn or its diameter is incorrect
Incorrect welding parameters
Worn liner
MMA WELDING PROBLEMS
Arc ignition problem
Incorrect connection of return cable or there is no
connection of return cable
Too low welding current
Excessive spatter welding with the problem
with the arc ignition
Incorrect welding polarity
Unstable arc, excessive spatter welding,
poor weld quality
Incorrect welding polarity
Electrode is damp or incorrectly heated
Unstable voltage in
No load voltage equals 0V
Damaged device
OTHER
Lights an abnormal indicator.
Overheat protection is on
Excessive welding current.
Exceeded duty cycle
The problem with setting welding parameters
Interference caused external factors
