Spartus EasyTIG 203P, Руководство пользователя

Страница: 23 / 28

USER’S MANUAL
EN
21
At least once a month:
• Regularly remove dust from inside of the machine. Use for this compressed air. The pressure
should be sufficiently low so as not to damage small components inside the machine. If in
the workplace, dust levels are high. You should clean machine often.
• Perform inspection of connection of internal electrical components. If anywhere the joints
are loose, tighten them.
Once a year:
• You should send device to an authorized service center for an interim review.
9. ENVIRONMENTAL PROTECTION
The product must not be disposed of into an ordinary waste container. It is totally
forbidden to dispose of electric or electronic equipment marked with a crossed-
-out trash can symbol by throwing it into ordinary waste containers. According
to the WEEE directive (directive 2012/19/UE), binding within the European Union,
such products should be disposed of according to local regulations.
We hereby inform the client that, according to the regulations, each commodity
is burdened with waste disposal costs (WDC) according to charging rates valid for a given year.
Attention! If using liquid to water-cooled torches, utilize it according to attached information.
10. TROUBLESHOOTING
Not all problems with functioning of the device, are the evidence of failure. You can independently carry
out an analysis in search of probable failure. In case of doubt, please contact to SPARTUS® dealer or
authorized service center.
During the warranty period all repairs should be carried by authorized service center. Repairs carried
out by unauthorized persons will void the warranty.
PROBLEM WITH TURNING ON THE MACHINE
After turning on the unit the fan is not wor-
king, digital meter is working. The unit does
not weld.
Incorrectly connected power. Switching on voltage
control system.
Unstable supply voltage. Too thin power cords or incor-
rectly connected power cables.
Incorrectly turned on power switch. Switching on
control system overvoltage.
Failure of power switch.
After turning ON the switch the device does
not correspond
Poorly connected to the supply voltage.
Failure of power switch
TIG WELDING PROBLEMS
The problem with TIG arc ignition (HF and no
HF). There is a spark when HF works.
Poorly connected TIG torch. Return cable
poorly connected or not connected.
Damaged current cable of TIG torch.