Spartus EasyTIG 203P, Руководство пользователя

Страница: 22 / 28

USER’S MANUAL
EN
20
7.7.7 MMA welding – adjustment
M1 Hot Start
M2
Welding current [A]
M3 Arc Force
8. MAINTENANCE
WARNING!
Before performing any maintenance or repairing of device, disconnect welding machine from
the power source and wait at least 5 minutes. The voltage accumulated in capacitors should
be discharged at this time to a safe level. But even after that operation you should be careful.
Make sure that the device is disconnected from the power source, and switch 8
is in the OFF posi-
tion, before connecting accessories and shielding gas to the device.
Maintenance and repair work may be performed only by qualified personnel with the appropriate per-
missions. Regular maintenance provides adequate service life and trouble-free operation of the device.
Routine maintenance (daily: before use/installation):
• Perform a visual inspection of the housing, knobs, control panel.
• Inspect (visual inspection) the power cord and power plug. Check the insulation of the cable.
• Check the condition of welding cables and their connectors. If cable insulation is damaged
– replace it. If connection is too loose – eliminate backlash.
• Check if cooling fan is working properly.
• Make sure that all vents are not obstructed.
BLUE KNOB
BLACK
M1
M2
M3
Control 203P DC 205P AC/DC
208P
AC/DC
210P
AC/DC
UP&DOWN in torch x
  
potentiometer in torch x
  
wire foot pedal x
  
UP&DOWN POTENCJOMETR FOOT PEDAL
7.7.8 Remote control