Spartus EasyMIG 220E PULSE SYNERGY, Руководство пользователя

Страница: 21 / 32

7.6. INSTALLATION – TIG WELDING
Before connecting hardware and shielding gas to the device, make
sure that the device is disconnected from power source and switch
(H) is in the OFF position.
7.6.1. CONNECTING THE GAS CYLINDER
1. The cylinder with appropriate shielding gas, should stand upright and be secured
against tipping over in accordance with safety requirements.
2. Make sure that the valve cylinder is closed.
3. Connect properly gas regulator to cylinder valve.
4. Connect the gas hose into gas regulator outlet. Use special clamps to seal connec-
tion.
5. Connect gas hose to the device (J)
Valve in the cylinder should be opened immediately before welding.
After welding is complete it should be closed.
7.6.2. TIG TORCH INSTALLATION
1. Connect properly TIG torch plug into DINSE „-” (G)
2. Connect properly TIG torch control plug into control socket (F). Pay attention to
suitable fi tting of control pins.
3. Connect gas hose into shield gas connector at the front panel. (E)
7.6.3. DEVICE INSTALLATION
1. Connect gas hose into device (see
7.6.1)
2. Connect TIG torch into device (see
7.6.2)
3. Connect return cable into DINSE
socket „+” (D) and the earth clamp
into workpiece.
4. Connect the welder into power
supply (see 7.4)
5. Turn on the welder by setting
power switch (H) in the ON
position.
6. Device is ready to work.
MIG
TIG
MMA
2T
4T
SPOT
PROCESS
TRIGGER
Alarm
Reduktor
z rotametrem
Przewód
powrotny
Uchwyt TIG
Element
spawany
:ąĪ
gazowy
Butla z
gazem
3U]HZyG]DVLODMąF\
~1× 230V
Przewód
roboczy
21
SPARTUS
®
Easy MIG * USER’S MANUAL
ENG ENG
Power cable
Work
cable
Welded
material
Control
cable
TIG Torch
Pressure
regulator
Gas
cylinder
Gas line