Spartherm M 700 INSERT, Инструкция по установке и эксплуатации

Страница: 52 / 60

52
7.8 CARE OF PLATED PARTS
If the appliance is equipped with plated parts, you must clean fingerprints
or other marks from the plated surfaces before operating the appliance
for the first time. Use a glass cleaner or vinegar and towel to clean. If
not cleaned properly before operating for the first time, the marks can
cause permanent blemishes on the plating. After the plating is cured, the
fingerprints and oils will not affect the finish and little maintenance is
required, just wipe clean as needed. Prolonged high temperature burning
with the door ajar may cause discolouration on plated parts.
NOTE: The protective wrap on plated parts is best removed when the
assembly is at room temperature but this can be improved if the assembly
is warmed, using a hair dryer or similar heat source.
8. REPLACEMENTS
Contact your dealer or the factory for questions concerning prices and
policies on replacement parts. Normally all parts can be ordered through
your Authorized dealer / distributor. FOR WARRANTY REPLACEMENT
PARTS, A PHOTOCOPY OF THE ORIGINAL INVOICE WILL BE REQUIRED TO
HONOUR THE CLAIM. When ordering replacement parts always give the
following information:
• Model & Serial Number of appliance
• Installation date of appliance
• Part number
• Description of part
• Finish
* IDENTIFIES ITEMS WHICH ARE NOT ILLUSTRATED. FOR FURTHER
INFORMATION, CONTACT YOUR AUTHORIZED DEALER.
WARNING
FAILURE TO POSITION THE PARTS IN ACCORDANCE
WITH THIS MANUAL OR FAILURE TO USE ONLY PARTS
SPECIFICALLY APPROVED WITH THIS APPLIANCE MAY
RESULT IN PROPERTY DAMAGE OR PERSONAL INJURY.
For chamotte replacement see chapter 5.1