9
2.3. ASSEMBLY / INSTALLATION
The ambiente a1/a2/a3/a4/a4 H
2
O/a5/a7/a8 stove must only be installed
on floors made of non-combustible materials with sufficient load-bearing
capacity. Please note the overall weight (see Technical Data). If necessary,
load-bearing capacity must be ensured by placing the stove on top of a
slab of non-combustible building material of sufficient thickness for weight
distribution purposes.
Stand the stove on the floor and level it horizontally, observing the safety
distances (refer to section „2.5. Fire Precautions“ on page 18). The legs
are height-adjustable.
2.3.1. FITTING THE FLUE GAS STACK
The ambiente a1/a2/a3/a4/a4 H
2
O/a5/a7/a8 is supplied ready assembled
as ordered. The flue gas outlet will be fitted at the rear unless otherwise
specified at the time of ordering. If the position subsequently has to be
changed, the following steps should be carried out:
ambiente a1/a2/a3/a4/a4 H
2
O
Changing installation from rear to top:
Remove the chimney connecting
piece if already fitted (
Fig. 2a Item A
). Remove the top cover panel and
the top flue gas connection cover panel (
Fig. 2a Item B
). Undo the screws
and remove the cover plate (
Fig. 2b Items B
and
C
). Then dismantle the
rear flue gas outlet connecting sleeve. Start by undoing the screws (
Fig.
2b Item D
). Fit the connecting sleeve for the top flue gas connection (
Fig.
2c Items E
and
F
). Then fit the cover plate for the rear flue gas connection
(
Fig. 2d Items E
and
F
). Finally, fit the rear flue gas connection cover (the
ambiente a4 H
2
O
ambiente a5
Fig. 1e
Fig. 1f
ambiente a7
Fig. 1g
ambiente a8
Fig. 1h
