5
Installing or Replacing the Battery
The battery is not required for normal operation when the RTS
receives adequate natural or artificial light. The battery can be used
during installation (start assist).
1. Remove the sensor from the back plate by pressing the key on
the lower edge of the sensor body and pull the body away from
the back plate.
2.
To remove old battery: Using a small flat head screwdriver or
pen as a lever, insert pointed end under the clear plastic battery
retaining clip’s edge and pop the clip off.
3.
Install or replace the battery in the clip with a new CR2032 coin
cell battery insuring the positive side (+) will be facing up.
4. Align the two straight edges of the re-
taining clip with the battery holder and
press the clip in with your finger.
Test Operating Modes
Ensure the RTS is fully charged or insert a
battery before entering test modes. The
following tests can be selected when in test
mode.
Light Level Test:
provides visual feedback of
the immediate energy produced by the solar panel.
1.
To enter Light Level Test mode, press and hold the occupancy/
test button for 6 seconds. The green LED will begin to blink.
2.
Press the test button again for 6 seconds to select Light Level
Test. The green LED will blink in accordance to the light level
it is detecting. This will change (2
second lag time) as you move the
sensor to areas with different light
levels. See following blink indicator
table.
Note:
Entering test mode section:
If the red LED blinks (no green LED)
after you have released the test
mode button, place the sensor under
a lamp with at least 100 foot-candles
(1000 lux) for 1 hour before retrying.
