Spartan Equipment SKID-PAC 1000, Техническое руководство

Страница: 31 / 48

Spartan Equipment Technical Manual Skid-Pac
TM
1000, 1000B
21
11.7.2 How To Check and Add Oil
Figure 11-2
Oil Fill Plug & Oil Level Plug
IMPORTANT
Contamination can shorten bearing life.
Avoid contaminating the oil by cleaning
the area around the oil level and fill plugs
prior to their removal.
1. Position Skid-Pac on flat stable ground
with easy access to both the oil fill and oil
level plugs. Shut down engine and secure
the parking brake. Relieve residual
hydraulic pressure in auxiliary circuit.
Follow carefully the instructions from the
carrier manufacturer.
2. Remove the oil level plug.
3. Check the oil level. When properly filled,
the oil level is visible at the bottom of the
oil level opening.
4. If oil is required:
Remove the oil fill plug.
Add oil until the level reaches the bottom
of the oil level opening. Do not overfill!
5. Install and tighten both the oil fill and oil
level plugs.
11.7.3 How To Drain Oil
1. Position Skid-Pac with the oil level plug
pointed downward so that oil will drain.
2. Remove oil level plug and drain oil.
3. If the oil is contaminated with water or dirt,
flush the eccentric housing with clean oil
prior to oil replacement.
4. Properly dispose of used oil. Obey all
local regulations for the disposal of these
fluids.
5. Add new oil.
11.8 How To Check Bearings
Because of the high loads and rotational
speeds, bearing failure is usually sudden. A
scraping or rattling sound is an indication of
imminent bearing failure.
Visually inspect the bearings for broken or
damaged components to determine if
replacement is necessary.
11.8.1 Bearing Replacement
2
4
Bearing service shall be performed in a
3
properly equipped workshop. Use of a manual
arbor press is recommended.
Figure 11-3 Proper Oil Level 1-Eccentric Frame,
2-Oil Level Decal, 3-Oil Level Plug, 4-Proper Oil
Level
NOTE: Bearings are interference press fit.
Apply contact pressure to the outer race only.
Do not hammer on the bearing rings.