Spartan Equipment SE112921, Руководство по установке

Страница: 9 / 26

INSTALLATION AND OPERATION
GENERAL INFORMATION
The SPARTAN EQUIPMENT tilt attach installs onto the toolbar/quick-attach
mechanism of your skid steer loader and also attaches to your attachment in the same
fashion as a universal quick attach. Due to this arrangement, thorough knowledge of the
skid steer controls is necessary
for machine operation. Read and understand your skid steer operator
’s manual instructions for
attaching and detaching an attachment.
INSTALLATION INSTRUCTIONS
1. Remove the shipping banding from around the tilt attach and skid.
2. Remove any attachments from the front of the loader.
3. Following all standard safety practices and the instructions for installing an attachment
in your skid steer operator
’s manual, install the tilt attach onto your skid steer.
NOTE: It is important to make sure the locking mechanism on your quick attach is en-
gaged, therefore locking the tilt attach onto the skid steer.
4. Lower the loader arms to the ground and remove the key.
5. Relieve any pressure from the auxiliary hydraulic system and install your hose kit to the
elbows on the top of the tilt attach and to the loader auxiliary hydraulics. If operating an
attachment (such as a bucket) that does not require hydraulics your tilt attach is ready
to accept the attachment.
6. Install the desired attachment to your tilt attach following the attachment manuals rec-
ommendations.
WARNING! ALWAYS CHECK LOCKING MECHANISM (PINS) BEFORE TILTING OR OP-
ERATING ANY ATTACHMENT.
If installing an attachment to your tilt attach that requires auxiliary hydraulics install one of the
valve kit packages.
POSTMASTER VALVE INSTALLATION (Refer to the diagram and parts list in the back of
instructions.)
1. Install valve mounting bracket to the top of
the tilt attach using the .38” hardware sup-
plied. Secure the valve #2243 to
the bracket using the .31” hardware supplied and
install the hose loop to the side of the tilt attach by removing one of
the .50” X 1.00”
capscrews from the left
side and replacing with the 1.25” capscrew supplied.
2. Install elbows #3430 to the existing elbows on the tilt attach followed by the 45° end of
the 16.5” hose and the 21” hose. Install straight adapters #62208 to the middle ports of
the valve and connect the 90° ends of the hoses coming from the tilt attach.
3. Install elbows #3283 to the right side ports in the valve and straight adapters #3324 to
the left ports of the valve.
4. Remove the power and return hoses from the postmaster and install them into the
straight adapters installed in step #8. Route hoses through the hose loop and up to the
auxiliary hydraulics on the loader.
11066 7-24-08-2