QUICK START
WWW.sparrl.com
5
5) QUICK TEST:
For a quick test you can follow the steps below.
i)
Power on the unit.
ii)
Check whether the LED indications are correct or not.
iii)
Press and hold the switch on the board for 10 seconds to load the default
configuration settings.
iv)
Check the LEDs are glowing properly or not (while pressing the switch on the
board the connection LED (D31) will turned OFF and after 10 seconds it will
turned ON, indicating the default settings has been loaded).
v)
Connect the LAN cable with the RJ45 connector on the EAD board.
vi)
Open the Internet explorer with the IP Address of EAD as web address (for
e.g.,
http://192.168.0.254
) as shown below.
