sparkfun MPR121, Руководство по подключению

Страница: 5 / 24

void readTouchInputs(){
if(!checkInterrupt()){
//read the touch state from the MPR121
Wire.requestFrom(0x5A,2);
byte LSB = Wire.read();
byte MSB = Wire.read();
uint16_t touched = ((MSB << 8) | LSB); //16bits that make
up the touch states
for (int i=0; i < 12; i++){ // Check what electrodes wer
e pressed
if(touched & (1<<i)){
if(touchStates[i] == 0){
//pin i was just touched
Serial.print("pin ");
Serial.print(i);
Serial.println(" was just touched");
}else if(touchStates[i] == 1){
//pin i is still being touched
}
touchStates[i] = 1;
}else{
if(touchStates[i] == 1){
Serial.print("pin ");
Serial.print(i);
Serial.println(" is no longer being touched");
//pin i is no longer being touched
}
touchStates[i] = 0;
}
}
}
}
The Arduino scans each electrode and prints out a message over serial if
an electrode is triggered as being touched. The Arduino will then print out a
message as soon as the electrode is no longer being touched.
Page 5 of 24