V.1605
Page | 15
Edit Spa List
Press on the pencil to edit your spa. You can rename the spa or delete it. To rename your spa
just click on the spa name and edit it as required. Press on SAVE to save the new name, or
press CANCEL to exit the edit box without saving. Press on DELETE to delete your spa from the
list (you may do this if the configuration process was unsuccessful and you need to setup your
spa again).
Troubleshooting Spa/WiFi Module Configuration
If you have completed the configuration process of adding a spa but it has failed to show online
after 5 minutes you should follow these steps to help overcome the problem.
Method 1: Ensure WiFi module has entered Infrastructure Mode
Once you have entered your wireless network password during the setup process the SpaNET
WiFi module should automatically change from hot spot mode (HOT) to infrastructure mode
(INFR). Occasionally something may occur during the setup process which will prevent this. To
ensure your WiFi module is in infrastructure mode follow these steps:
1)
On the spa side keypad press and hold the [UP] + [DOWN] buttons until display shows
“MODE”
2)
Press the [DOWN] button until display shows “WIFI”
3)
Press the [OK] button to enter WIFI menu (display will show “HOT”)
4)
Press the [UP] button to change display to “INFR”
5)
Press the [OK] button to confirm INFR (infrastructure) mode (display will briefly show
“WAIT” and then return to the default temperature display)
After these steps allow the WiFi module another 5 minutes to login to your wireless router and
obtain Internet access, then login to the SpaLINK app again and check your spa list. Refresh
your list several times until spa appears online.
Method 2: Delete the spa and run the setup process again
The WiFi module requires reasonable WiFi signal strength (-80db or above) from your wireless
router as well as a correct password to login to your router and obtain Internet access. During
the setup process it is easy to skip past the signal strength without checking it in detail, and it is
also easy to make a typing mistake with the network password. To correct these items the spa
should be deleted from your spa list and the configuration process carried out again.
1)
Open the app and login to your spa list page. Press on the edit pencil, press DELETE and
confirm OK to delete your spa from your spa list.
Содержание SV SmartLINK
Страница 1: ......
