SpaNet SHP-100P, Инструкции по установке и обслуживанию

Страница: 9 / 21

9
Check current temperature:
◎
Under running, press
“SET” button 5 seconds and “ ” or “ ” to check the current
status of the unit. You can check Water Temp-/Compressor protection exhaust Temp-/Heat
Copper Temp-/Return Gas Temp-/Ambient Temp-/Cooling Copper Temp-/ Actual open steps of
EE valve. If no buttons are depressed within 5 seconds, the LED will display water temperature.
When the unit is switched off, Current time is displayed.
Setting the time
press “ ” botton to set the time. The time displayed blinks, press “ ” botton again and then
use the arrow
“ ” and “ ” to change the hour setting. To change the minutes, press
“ ” botton again. Once the correct time is set. press “ ” botton again the end. The display
returns to normal.
Timer switch ON and Timer switch OFF:
Once the time has been set correctly, this function allows a machine start time and a machine
stop time to be programmedduring the day
P
ress “ ” botton the time displayed and “ ” to blink. Change the hour using the “ ”
and
“ ” keys. Press “ ” botton again to change the minutes using the “ ” and “ ”
keys. P
ress “ ” botton again the display returns to normal.
P
ress “ ” botton the time displayed and “ ” to blink. Change the hour using the “ ”
and
“ ” keys. Press “ ” botton again to change the minutes using the “ ” and “ ”
keys. P
ress “ ” botton again the display returns to normal.
The time setting is from 0 to 24 hours to recycle.
When the setting time for on and off is the same,the setting time is not available.
When the setting timer(displayed blinks), Press
“ ” to deactivate TIMER.
Coercive Defrosting:
1.
press “ ” botton 5 seconds when the unit is heating mode, the unit go to defrost state.
2.
When fulfilled defrost stop conditions, defrost is stopped.
3.
After exiting the defrosting, the unit will stop 30 seconds, then it will heat mode again.
Key lock:
press “ ” and “ ” 3 seconds, To set keylock.
Press
“ ” and “ ” 3 seconds again to release keylock.