Installation P/N 73-200-0300, Rev. A, 9/04/2015
DO NOT POWER UP THE SPA UNLESS THE SYSTEM IS COMPLETELY INSTALLED AND THE SPA IS COMPLETELY
FILLED UP WITH WATER. Doing so can cause a dry fire, which can damage the heater and controller, and will void the
warranty.
After installation is complete, completely fill the spa with water to the required level. Refer to the Spa Owners Manual for the required
water level. We recommend using the “Pure Fill Spa Pre-Filter” for fresh clean water. DO NOT OVERFILL. Overflowing the spa will
cause water to infiltrate the system and other electrical parts. Damages caused by water infiltration will not be covered under warranty.
Once the spa is completely filled to the required level, then power up the spa and purge the water lines to help remove air from the lines.
The “Pr” message will appear on the topside panel which indicates water purging is required or is in progress. If the pump is not running,
press on the Jets key to activate the pump on high speed. You may also bleed air out of the plumbing by loosening the plumbing fittings a
bit, and then run the pump high speed on/off until all the air is out. Once there is constant strong water pressure from the jets, you can
now proceed with normal operations. Make sure all plumbing fittings are tighten, and fix any water leak right away.
System Maintenance:
It is recommended to monitor the spa equipment every month. Check out for water leaks, internally and externally,
and for abnormal operations. Get it repaired right away if there is a problem. Don't allow the problem to get worst. It is recommended to
inspect for any loose connections and for any damaged cables every 3-6 months (especially on the power terminal block, component cord,
and sensors). Loose connections will cause improper operation and overheat the wires. Damaged cables are mostly cause by rodents.
Spa Maintenance:
Use ONLY Spa rated chemicals. We recommend using ozone, Mineral Cartridges and a small amount of chemical to
treat the water. Ozone and Mineral Cartridges reduces maintenance and decreases the use of chemicals up to 90%. Keeping the water
balanced is required. Soften water and salt is corrosive to heater elements that are made out of Incoloy metal. We also recommend to test
the spa water every single day, and treat the spa water as needed.