Page 11
WARNING
Excessive Weight
Require three or more person to move and
install this range hood. Spinal or other bodi-
ly injuries could occur if it is not followed.
Installations
(refer to Page 4 for parts)
:
Measure the distance between stove top and the bottom of
range hood. A distance of 28” to 36” is recommended*.
*Due to different ceiling height configurations, recommend
-
ed height may not be applicable.
1.
Using references in
Height & Clearance
on Page 5 and
Measurements and Diagrams
on Page 15, mark the leveling point of the hood. Position two mounting screws
on the wall, leaving 1/8” space away from the wall.
2. Measure the width of the chimney then position the chimney-mounting brackets
directly
above the hood-
mounting bracket, mark the leveling points and secure it using four mounting screws.
NOTE: DO NOT USE threaded drywall anchors to support the hood when mounting the hood on sheet
-
rock. Mounting the hood on wall studs or lumbars is highly recommended.
3. Attach the hood-mounting bracket to the back of the hood with four screws as shown in Figure 1.
4. Align hood-mounting bracket to the screws on the wall and hook hood into place as shown in Figure 2 and
Figure 3. Tighten screws to secure hood to the wall.
CAUTION: Make certain the range hood is secure before releasing!
5.
For safety purpose, pre-drilled mounting holes are provided through the back of the hood. For a more secure
installation, use as many mounting holes as needed to secure from the inside of hood.
6.
Use 6” round steel pipe (follow building codes in your area) to connect the exhaust on the hood to the duct
-
work above. Use silver tape or duct tape to make all joints secure and air tight. Refer to Figure 4.
SAFETY WARNING: Risk of electrical shock. this range hood must be properly grounded. Make sure this
is done by qualified electrician in accordance with all applicable national and local electrical codes. Before
connecting wires, switch power off at service panel and lock service panel to prevent power from being
switched on accidentally.
Installation
(Continued)
7.
Connect the range hood to a designated standard outlet (please
refer the product label for the suitable voltage of this unit)
or cut off the plug and connect three wires (black, white and
green) to house wires and cap with wire connectors. Connect
according to colors (i.e. black to black, white to white, and
green to green).
8. Store excess wires in the wiring box.
9. Install both chimneys and tighten screws to secure the lower chimney to the range hood as shown in Figure
5.
10. To avoid scratching the chimney, extend the upper chimney slowly and carefully to the chimney-mounting
bracket and tigten screws as shown in Figure 6.
11. To install stainless steel baffle filters, refer to Figure 7 for the following five steps:
Angle baffle filter toward back of hood.
Push baffle filter up until almost level.
Slide forward into recess behind the front of hood.
Lower baffle filter.
Slide back until it fits into resting positions.
12. Repeat Step 12 to install all stainless steel baffle filters.
13. Turn powe ON in control panel. Check all lights and fan operations.
14. Make sure to leave this Installation Guide for the homeowner.
Installation
Figure 8
Page 10
Figure 5
Figure 7
Figure 4
Figure 3
Figure 2
Figure 1
Figure 6
