Instruction manual
SPACE s.r.l.
ARS680WS - ARS680 WD - ARS660WD
Code M0203 - rev.1.0
(11/2010)
SPACE s.r.l. a s.u. -
Via Sangano, n° 48 - 10090 Trana (Torino - Italy)
Page 27/52
Tel. (+39) 011/934.40.300 – Fax . (+39) 011/933.88.64
e-mail: [email protected]
The different phases can be followed by looking at the red LED on the keypad of
each detector:
Red LED flashes when wheel has to be turned.
Red LED turns off when one of the three points is being sampled
Red LED is steady when the procedure has been completed.
NOTE 2 :
During system configuration, you can also define that procedure is carried out on 2
points instead of 3. This means that wheel will be turned twice by 180°, instead of
being turned three times by 120°, as described above.
8.5.2 Thrust Run-Out with Automatic Acquisition
To carry out the thrust Run-Out with automatic acquisition procedure, press F3 to select
“thrust Run-Out” during the preliminary operations (see par. 8.4.2 on page 23)
.
The following screen will be displayed:
Figure 33
To carry out the thrust Run-Out operation, it is recommended to carefully follow the
displayed instructions.
RELEASE
detectors, so that they are free to oscillate upon wheel movement. Wait for
detectors to stop oscillating, and start moving vehicle backwards, very slowly, until the
rotation of the wheel has turned 30 degrees. You can observe this rotation on the 3-point
races of the clamps.
Figure 34
Vehicle
matches target
point
Vehicle thrust
direction (back)
Vehicle
starting point
Vehicle target
point 30°
