Space-Ray ERP10, Инструкция по установке, обслуживанию и эксплуатации, Страница: 6 / 22

Page 4 of 20
2. UN-PACKING
The appliance is supplied in a carton, assembled complete and ready for installation. Any optional equipment
supplied is packed inside the carton also.
3. INSTALLATION
Not withstanding their limited scope, the appliance should be installed in accordance with the relevant
provisions of any National Gas Safety (Installation and Use Regulations). Due account should also be taken of
any obligations arising from any National Health and Safety at Work Regulations, National and Local Building
Regulations and National Electrical Wiring Regulations. The appliance must be installed, and where necessary,
converted for use on other gases, by a qualified installer.
3.1. Suspension
3.1.1. The appliance should be located with respect to building construction and other equipment, to permit access to
the appliance for servicing etc.
3.1.2. For suspending the appliance, it is recommended that suitable protected welded chain (ø3mm x 65 links/m) or
ø6mm (minimum) mild steel drop rods and suitable brackets are used. Attach the chains or drop rods to the 4
holes located in the Side Frame Panels (as shown in Fig.1.), by use of M8 screws and nuts. Providing at least
Ø5mm closed link hooks are used, chains may be attached directly to the 4 holes in the appliance Side Frame
Panels, providing that the hooks are manually crimped closed by the installer.
3.1.3. The appliance must be suspended with its manifold axis horizontal, but may have the axis at 90
o
to the manifold
either horizontal (10
o
- ERP40/45) or at an angle of up to 35° (maximum) from the horizontal, as shown in Fig.
2. below.
IMPORTANT: When suspended at an angle from the horizontal, the appliance MUST be positioned with the
manifold along the lower horizontal side of the heater.
3.1.4. The appliance may be mounted off a vertical surface also in which case it is recommended that use is made of
the purpose designed pair of brackets that are available as optional equipment
3.1.5. The brackets should first be fixed to the vertical surface by means of 4 bolts (M8 minimum) through pre-formed
holes in the brackets. Attach the brackets to the 4 holes in the Side Frame Panels of the appliance by use of
M8 screws and nuts.