The Air Button controls an auxiliary air blower. It is used to turn the blower on and off, and select different
operating modes if a Spa Power Variable-Speed Blower (SPVSB) has been fitted. 2 pushes (STD) or 4
pushes (SPVSB) of the air button cycles the blower as follows:
Auxiliary Air Button
Standard Air Blower (STD)
When the light is on pressing the Down button
will put the light into adjustable colour mode and then
sequentially select through all the available colours. The last colour set in this mode will be remembered the next time
the light is used.
Adjustable Speed Mode
If a Spa Power Variable-Speed Blower is fitted, the spa user has the ability to adjust the blower speed to
any desired setting. The Up and Down buttons are used to set the desired blower speed. Note: If the
blower is in Full Speed or Oscillating modes then pushing the Up or Down button will put it into
Adjustable Speed mode and then adjust the speed.
AIR
Light turns
to orange
Step 1) Press Air Button
to set Adjustable Speed Mode
Step 2) Press Up
to
speed of blower
Step 3) Press Down
to
speed of blower
twice
increase
decrease
Push 1 - Blower ON
Push 2 - Blower OFF
Push 1 - Blower ON (Full Speed)
Push 2 - Blower ADJUSTABLE (Adjustable Speed)
Push 3 - Blower OSCILLATING (Oscillating Speed)
Push 4 - Blower OFF (Default State)
AIR
Red
Light
AIR
Orange
Light
AIR
Green
Light
AIR
No
Light
Spa Power Variable-Speed Blower (SPVSB)
(if fitted)
Page 3
Page 4
Light Operation
The multi-function Light Button
is used to turn the light on and off and select the different
operating modes of the Spa Power Variable Colour Light. Five short presses of the button will cycle the
light as follows:
Push 1 - Light ON
Push 2 - Light ADJUSTABLE
Push 3 - Light SLOW CYCLING
Push 4 - Light FAST CYCLING
Push 5 - Light OFF
(Colour - White)
(Adjustable Colour Mode - User selects colour of choice)
(Cycle through colours - slowly)
(Cycle through colours - quickly)
(Default State)
Light Button
Note: If left on, this accessory will automatically switch off after 20 minutes. If the heater element is on, switching on
this accessory may cause the heater to loadshed and switch off. This is to keep the total power load to a safe level.
Indicator Light
ON
A small red dot in the bottom corner of the digital readout indicates when the light is
turned on. If left on the light will automatically switch off after 30 minutes.
Note: This is a multi-function button which performs the following -
1)
Short presses of the button activate the light functions as detailed above.
2)
Holding the button will begin to increase the set temperature of the spa.
3)
When a Spa Power Variable Speed Blower is fitted and is turned on the button increases the blower speed.
Adjustable Colour Mode
Safety Notes
Before using ensure that the spa pool has been connected to a suitable weather protected outlet socket, equipped
with a double pole isolating switch, which is of the correct rating and complies with the local wiring regulations.
When installing refer to your local wiring code. In particular refer to ECP 2 & ECP 25 (AS / NZ) and EN 60364-4-1 &
EN 60364-7-1 (EU). The system must be installed in such a way that live parts are not accessible by a person in the
pool. If a supply cord is not fitted the system must be permanently connected to fixed wiring through a 30mA or less
RCD.
This appliance is not intended for use by young children or infirm persons without supervision. Young children
should be supervised to ensure they do not play with the appliance.
