85
3. Press <ALT> <F2> after memory initialization.
4. The system will now automatically flash and reboot.
Note:
That flashing from the BIOS is only possible if you use a
normal floppy drive. It can’t flash from any other device.
After flashing the BIOS, my system will not boot-up.
1. Try clearing the CMOS RAM.
2. The BIOS chip is defective due to an unsuccessful flash, contact
your nearest SOYO branch for re-flashing.
Is there a way to reprogram my BIOS after an unsuccessful flash?
There is no other way, you need to send back the BIOS ROM to your
nearest SOYO branch for re-flashing.
VGA Issue
I cannot set my VGA to go higher than 16 color (640x 480).
1. Make sure that you have installed the VIA 4 in 1 driver set.
2. Install/
re-install
the
VGA
driver.
After wake-up from Suspend to RAM or Standby mode, the screen
has no display but I can hear the hard disk operating (For External
AGP card).
Check your VGA card’s manufacturer for a driver and VGA BIOS update,
make sure the VGA card supports the Suspend to Ram function.
Audio Issue
How can I disable the on-board Audio?
Go to “Integrated Peripherals\VIA Onchip PCI Device” in the BIOS setup,
then set the “AC97 Audio” to disabled.
I cannot get the sound working on my system.
1. Check if the speaker wire is connected to the line out connector in
the M/B.
2. Check if your speakers are powered on.