Hardware Setup
SY-6IZM/3
26
Step 12. CMOS Clearing (JP5)
After you have turned off your computer, clear the CMOS memory
by momentarily shorting pins 2-3 on jumper JP5, for a few seconds.
Then restore JP5 to the initial 1-2 jumper setting in order to recover
and retain the default settings.
Jumper JP5 can be easily identified by its white colored cap.
CMOS
Clearing
Retain CMOS Data
Clear CMOS Data
JP5
Setting
Short pin 1-2 to
retain the new
CMOS settings.
Short pin 2-3 for
at least 5 seconds
to clear the CMOS.
Note:
You must unplug the ATX power cable from the ATX power
connector when performing the CMOS Clear operation.
Step 13. Enable/Disable Onboard VGA(JP7)
The onboard VGA features of your Motherboard are controlled by
jumper JP7.You can choose to enable or disable the available VGA
function by setting JP7 accordingly.
l
Leave JP7 open to enable the onboard VGA function. Then,
you can plug your VGA device monitor, after the Motherboard is
installed. (You do not need to install any VGA card.)
l
To disable the onboard VGA options short pin JP7.
Onboard VGA
Disable
Enable
JP7 Setting
Short pin to
disable t he
onboard VGA
function.
Open pin to
enable the
onboard VGA
function.
2
1
3
2
1
3
