14
Hardware Setup
Connectors
Attach the mainboard to case devices via connectors on the mainboard.
Refer to Figure 1-1 for connector locations and connector pin positions.
Front Panel Connectors
Connector’s
Name
Description
HD LED
IDE device LED connector: Attach a 2-pin IDE drive
LED cable to this connector. The LED lights when an
IDE device is active.
KB_LOCK
Keylock & Power LED connector: It is a 5-pin
connector for a lock that may be installed on the system
case for enabling or disabling the keyboard. It also
attaches to the caseÕs Power LED. Pin 1, 3 are for power
LED and pin 4, 5 are for keylock.
PW2
ATX power on/off switch connector: Attach a 2-pin
momentary type switch to this connector for turning on
or off your ATX power supply.
RESET
Hardware reset switch connector: Attach 2-pin hardware
reset switch to it. Closing the reset switch restarts the
system.
SPEAK
PC speaker connector: Attach a 4-pin PC speaker cable
from the case to this connector.
TB LED
Turbo LED connector: Attach a 2-pin turbo LED cable
to it. The LED lights when the system is in turbo mode.
Manufacture default has set the board in turbo mode due
to most of hardware and software are compliance to
turbo mode.
