Switch DIP SW-1 to “ON” position.
Switch DIP SW-2 to “OFF” position.
Switch Jumper J3, J4 and J5 to NET position.
Switch Jumper J2 to NET position.
1
2
3
4
a. Power off and plug in CAT5 cable to AR-716E
b. PCB diagram as follows by using DHCP function
c. Power on. In begging state the ACT LED will flashing, after IP has got ACT LED
will off and auto save the new IP address to EEPROM.
d. Power off.
e. Shift JP2 jumper RS-485 position.
f. Then, Switch DIP SW-1 to “OFF” position and Switch DIP SW-2 to “ON” position.
( return to Serial Setup Mode)
g. Connect Converter (RS485 to RS232) to the HOST of the PCB.
h. Power on.
i. To modify parameter on the TCP/IP module through the Hyper-Terminal function
of the Window. (Start → Programs → Accessories → Communication →
Hyper Terminal)
j. Click “Hyper-Terminal”. Shown as follows:
k. Key-in any temporary name.It is not important matter.
l. Choose which COM port that Converter (RS485 to RS232) connect and click
“ OK ” to exit.
n. TCP/IP module already gets IP address now shown as follows:
Note that save it after set all parameters.
o. Power off. Then switch DIP SW-2 to “OFF” position, shift JP2 jumper to “ NET ” position and take off Converter.
v070604
m. Set up COM oort properties as 9600, 8,None, 1, and click “OK”
to save.
3
2.Get IP address by DHCP server
1 2
4
3
TCP/IP module Ver: 2.07
AR-716E
SOYAL
