22
2. FITTING AN ACCESSORY (SEE FIG. B1, B2)
Press the spindle lock button. Hold down and rotate the
spindle by hand until the spindle lock engages with the
spindle. Loosen the collet nut anti-clockwise using the spanner
if necessary.
Fully insert the tool shank into the collet. Tighten the collet nut
with the spanner but do not over-tighten. Finally release the
spindle lock button.
WARNING!
Do not engage the spindle lock button
while the tool is running.
B1
B2
20
IMPORTANT:
When charging, the charger and
tool may become warm to the touch, this
is normal and does not indicate a problem.
WARNING! When the battery charge runs out after
continuous use or exposure to direct sunlight or
heat, allow time for the tool to cool down before
re-charging to achieve the full charge.
Power
outlet
Charger
plug
A
8
7
24
