Flat ribbon
cable stripper
8P (RJ45)
Crimp
6P (RJ11, RJ12)
Crimp
Latch
Round cable
stripper
Front Side
of Tool
WARNING:
Tool is not insulated. Never use tools
on live circuits. Wear eye protection when using tools.
Keep fingers away from crimping mechanisim and cutting
blades when using tool.
Instructions
Cutting flat and round cables
1. Squeeze the handles and push the latch outwards to open the tool.
2. Insert the cable through the cutter from the
back side
on the tool.
3. Squeeze the handles until the tool is fully closed.
4. Release pressure on the handles to allow the tool to open up.
5. Remove the cut cable.
Stripping flat phone cables
1. Squeeze the handles and push the latch outwards to open the tool.
2. Insert the cable through the flat cable stripper from the front side
on the tool.
3. Squeeze the handles so that the tool is completely closed and
hold closed.
4. Pull on the cable to remove the stripped cable.
Crimping modular connectors
1. Wire the module plug according to the connector manufacturer’s
instructions and required pin out.
2. Squeeze the handles and push the latch outwards to open the tool.
3. Insert the modular plug with the key tab facing downward into
the proper crimping cavity (see chart below).
4. Squeeze the handles until the tool is completely closed.
5. Release pressure on the handles to allow the tool to open up
and remove the crimped modular plug.
Stripping round data cables
1. Squeeze the handles and push the latch outwards to open the tool.
2. Insert the cable through the round cable stripper from the
front side on the tool.
3. Squeeze the handles so that the tool is completely closed and
hold in place.
4. Gently rotate the tool radially around cable to score the cable
jacket. DO NOT use the tool to pull off the outer jacket.
5. Release pressure on the handles to open the tool.
6. Remove the cable from the tool and use your hands to remove
the outer jacket.
04/14 Rev. 0
Contents Made in Taiwan
Product distributed by Southwire Company, LLC
One Southwire Drive, Carrollton, GA 30119
©2014 Southwire Company, LLC. All rights reserved.
southwiretools.com
1-855-SW-T00LS
Toll Free Technical Help
Línea de Ayuda Técnica Gratuita
Scan for a how-to video,
warranty information and
to access our mobile site.
Escanea para video
RJCC-T1 Compact
Voice & Data Crimp Tool
Tool Description
Back Side
of Tool
4P (RJ22)
Crimp
Cable
Cutter
Stripping round data cables
(cont.)
7. Inspect the wires to make sure the insulation is not nicked.
If it is, cut the cable again and repeat steps 1-6.
Connector type Crimp cavity Crimp location
RJ45 8P Front of tool
RJ11 and RJ12 6P Front of tool
RJ22 4P Back of Tool
•
Twisted Pair (CAT 3, CAT 5, CAT 5e, CAT 6)
•
RJ45, RJ11, RJ12, RJ22
