PULLING OUT EXTRA WIRE
1. When wire appears out of conduit and down pullers shaft,
turn off dill motor.
2. Unwrap rope from capstan and extend rope around Lower
Pulley then back up to capstan (Fig 14).
3. Wrap rope around the capstan in a clockwise direction from
the inside out.
4. Continue wire pull until desired length is pulled out or until
wire reaches lower pulley.
TROUBLESHOOTING
1. Make sure capstan rotates in a clockwise rotation. If
rotating in a counter clock rotation the drill motor is in
reverse, turn off drill and switch the motor to the forward
rotation.
2. Tighten all three chuck holes when attaching drill to chuck
adaptor. Check drill chuck for tightness before every pull.
MAINTENANCE
• Gearbox is filled with high temperature lubricating grease.
No maintenance is required.
• Drill shaft is equipped with a six sided harden steel extension.
If you chuck all three chuck holes you should not have
slipping. If for any reason this shaft is worn down or stripped,
call your local distributer or Southwire Tools and Equipment
for a replacement.
16
15
SET UP AND OPERATION
EXPLODED DIAGRAM
SPECIFICATIONS
• Model# M3K-M
• Stock # 57-64-84-01
• Length (Fully Extended)- 98 Inches
• Length Disassembled- 37 Inches
• Width- 11 Inches
• Weight with Motor and Cart – 126lbs
• Pulling Rope Minimum Average Breaking Strength- 12,000lbs
• Pulling Speed Low- 25 fpm (No Load)
• Pulling Speed High- 100 fpm (No Load)
• Recommended Pulling Rope- 5/8 Inch or Larger
• Patent Number – US 6,682,050
Fig 13
Fig 14
Fig 12
P3-206
P3-206-1
P3-002-1
P3-002-2
P3-002-4
P3-202
P3-203
P3-17
P6-10
P3-33
P3-34
P3-18
P3
-
203-2
P3-204
P3-205
P3-002-18
P3-002
P3-201
P3 002-18
P3
-
208-51
P3
-
13
P3-122
P3-118
P3-122
P3-118
P3-208-52
P3
-
207
P3-208-54
P3-208-55-A-H
P3-208-53
P3-208-56
P6-209
